Original Item: Only one available. This is an excellent example of the Model 1891 Argentine Mauser carbine, one of many "export" models made for foreign governments, all based on the Mauser Model 1889. A lovely example that looks to have seen a good amount of service but was well cared for.

This example, like all of the Argentine Mausers made before 1896, was made by the renowned Company LUDWIG LOEWE of BERLIN, which from 1887 was actually part owner of Mauser Waffenfabrik. It is marked with matching serial number A 7859 on the barrel, receiver, bolt, magazine, and stock. The stock however looks like it may have been re-marked at some point, as we can see fainter numbers to the left of the marking, which we cannot read. The Ludwig Loewe serial number records for the Argentine contract indicate that carbines bearing serial numbers A5000 to A9999 were produced in 1895, so this carbine was made probably made after the middle of that year. There were also surplus receivers made, which were then used later.

In late 1886, following the death of Ludwig Loewe, his younger brother Isidor took over the running of the company, and by the end of the year it became part of the legendary Deutsche Waffen- und Munitionsfabriken Aktiengesellschaft (German Weapons and Munitions public limited company), usually referred to as DWM. All Argentine Mausers made after this point were DWM marked, so any Loewe marked Mauser rifles are definitively Pre-1899 manufacture and considered antique by Federal law.

The left side of the receiver is marked with the production information:

Unlike almost all of the Argentine Mausers we have seen, this one never had the Argentine Crest removed from above the chamber. This shows a Sun wreathed panel with a sun on top, and a "Phrygian Cap" on a pole in the center, with two clasped hands below. The marking is still quite crisp, so we do not believe that this carbine was arsenal refurbished at any time, which would have made the fine lines faint. The "Clasped Hands" markings is present on other components as well, such as the firing pin holder and bolt release.

The original dark blued finish on the metalwork has worn in areas, particularly on the barrel and receiver, as well as on top of the barrel forward of the hand guard. We do not see any signs of the finish being retouched, and the magazine follower and bolt release spring no longer show the original "niter blue" finish. The markings are still all relatively crisp, worn a bit from service.

The metal finish is very good, with lots of the blue finish still present on the receiver and barrel, which does look like it may have been retouched at some point, as the same finish is present on the bolt release spring, which should be "niter blue". The markings are all still very crisp, so if it was refinished, it was expertly done at arsenal. The bolt is still the correct bright steel, with just a bit of staining on the handle.

The stock on this example shows wear from use and service, and probably was worn down a bit from cleaning, so the cartouches are no longer visible. We can see a crack along the grain near the lower toe of the butt stock, which does not look to have been repaired. The stock is made from lovely "flamed" wood, which does unfortunately make it a bit more prone to cracking along the wavy grain, which this example has. The rear sling loop is still under the wrist and has not been moved to the side. There is no front sling swivel, as is correct.

The carbine cycles correctly, with a crisp dry fire and no issues we can see, though we have no ability to check to see if the magazine still feeds correctly. The safety on the bolt is fully functional, locking the action closed and preventing firing when moved to the right. The bore is in very good condition, showing a bright finish with strong lands and grooves. There is some wear and rounding to the lands, so the carbine did see service, but was well cared for.

Another Military Contract from the Victorian era that Mauser managed to snag from all its European competitors. In very good condition with an lovely flamed wood stock. Ready to display!

Specifications-

Year of Manufacture: 1895
Caliber: 7.65×53mm Mauser
Cartridge Type: Centerfire Cartridge
Barrel Length: 17 1/2 Inches
Overall Length: 37 Inches
Action type: Bolt-Action
Feed System: 5 round box magazine

More on the Model 1891 Argentine Mauser:

After the Mauser brothers finished work on the Model 71/84 for Germany in 1880, the design team set out to create a small caliber repeater that used smokeless powder. Because of setbacks brought on by Wilhelm Mauser's death, they failed to have the design completed by 1882, and the German Rifle Test Commission (Gewehr-Prüfungskommission) was formed. The commission preferred to create their own design, which was what became the Gewehr 1888, often called the "Commission Rifle".

In the meantime, Paul Mauser created two different variations of the same rifle, one with a stock strengthened with a barrel shroud and a traditional design following the layout of the 71 series, in hope he might be able to overturn the commission's decision, or at least sell his design to the Kingdom of Bavaria, which adopted its own arms. The two rifles became known as the 89 Belgian (with a barrel shroud) and the 91 Argentine (with a 71 layout) Mausers, identical in their function and feed system. The main features were the ability to use stripper clips to feed the magazine (a revolution in rate of fire), and its rimless cartridge (7.65 Argentine Mauser), advanced for the time.

The Mauser Company then set about trying to sell this new design. Unfortunately they failed to convince the Commission to reverse its decision, and the attempt to win over Bavaria did not succeed either. However, Mauser already had supplied arms to numerous countries, and when they were looking to update their rifles, they came back to Mauser. At the time, Belgium was looking to bolster its domestic arms industry, and felt that manufacturing a Mauser Design would really help them in this goal. This resulted in the founding of Fabrique Nationale d'Armes de Guerre, owned in part by Ludwig Loewe, to manufacture the Model 1889 Belgian Mauser. This company would go on to become a major arms manufacturer, which exists today as FN Herstal.

At the same time, the Ottoman Empire had a contract for Model 1877 Turkish Mausers, which were based on the model 1871. The contract however had an "escape clause" that allowed them to change the contract in the event of a more advanced Mauser system being developed. This resulted in a new contract for the Model 1890 Turkish Mauser. While this was taking place, the Argentine Small Arms Commission contacted Mauser in 1886 to replace their own Model 71s. Since they wished to keep retraining of their armed forces to a minimum, they went for the Mauser 91, as the operating principles were identical. As with other early Mausers, most such arms were made by the Ludwig Loewe company, who in 1896 joined with other manufactures to form Deutsche Waffen und Munitionsfabriken.

One of the principal defining features of the Belgian/Turkish/Argentine Mauser was its thin sheet steel jacket surrounding the barrel—a rather unusual element not common to any other Mauser mark of note. The jacket was instituted as a feature intended to maintain the effectiveness of the barrel and the solid wooden body over time, otherwise lengthening its service life and long-term accuracy when exposed to excessive firing and battlefield abuse. In spite of this approach, the jacketed barrel proved susceptible to moisture build-up and, therefore, introduced the problem of rust forming on the barrel itself–unbeknown to the user. In addition, the jacket was not perforated in any such way as to relieve the barrel of any heat build-up and consequently proved prone to denting. As such, barrel quality was affected over time regardless of the protective measure. Furthermore, another design flaw of the jacket was its extra steel content. Not only was it expensive but it was also needed in huge quantities to provide for tens of thousands of soldiers. By many accounts, the barrel jacket was not appreciated by its operators who depended on a perfect rifle in conflict. Another defining characteristic, unlike most Mausers, was a spring-loaded cock on closing bolt action resembling that of the British Lee-Metford, which predates the Mauser 1889 by five years. This development allowed for faster firing and was well received.

IMA considers all of our antique guns as non-firing, inoperable and/or inert. Title 18, U.S. Code, Section 921(a)(16) defines antique firearms as all guns made prior to 1899. This law exempts antique firearms from any form of gun control or special engineering because they are not legally considered firearms. No FFL, C&R or any license is required to possess, transport, sell or trade Antique guns. All rifles and muskets sold by IMA that were manufactured prior to 1899 are considered Antiques by the US BATF (United States Bureau of Alcohol, Tobacco & Firearms). Therefore, all of IMA's Antique guns may be shipped to most US States and most U.S. territories.

These antique guns are not sold in "live" condition, and are not tested for the the ability to feed or load any type of cartridge. They are sold as collector's items or as "wall hangers" not for use, and we make no guarantees regarding functionality aside from what is stated in the description. Any attempt at restoring an antique gun to be operational is strongly discouraged and is done so at the risk of the customer. By purchasing an antique gun from IMA you thereby release IMA, its employees and corporate officers from any and all liability associated with use of our Antique guns.

Pre-1899 Manufacture, no licenses required, allowed to ship to most addresses within the United States.